Hotline：
13962694808 15151626266◆ when all materials are evenly mixed by gravity metering, the micro metering can be strictly controlled with an accuracy of + 0.1%;
◆ automatic repeated calibration function, which will automatically calibrate the program after each weighing to ensure the best batching accuracy;
◆ it has the function of formula storage, which can store up to 100 groups of formulas;
◆ alarm history recording function;
◆ sgb-600 and below series are machine mounted as standard; Sgb-1200 and above The upper series is equipped with tripod mounting type as standard (equipped with tripod, storage bucket and pneumatic discharge valve);
◆ each model is equipped with a set of secondary blanking valve as standard, which is used to measure the component ratio between 0.5% and 5%;
◆ it has Ethernet communication function to realize networking and centralized control function with molding machine;
◆ with automatic material suction control function;
Optional devices:
◆ optional material level gauge at the bottom of the batching hopper is convenient to alarm in advance when the raw material is short of material;
◆ when the machine is used for ground installation, it needs to be equipped with tripod, pneumatic discharge valve, storage bucket and suction bucket (suitable for sgb-600 and below)
◆ optional vacuum generator SVG and Europeanized central vacuum hopper shr-u-st;
◆ sgb-40 / 200 / 600 can be equipped with micro metering valve to calculate the proportion of materials from 0.2% to 0.5%:
◆ special material metering valve can be selected to calculate flakes or irregular crushed materials within 12 * 12 * 12mm;
◆ optional data acquisition function, which can read the actual proportion, output and accumulation of each batch of raw materials, recycled materials, color masterbatch and additives
Dosage and production rate;
◆ optional automatic compensation function for recycled materials (low material switch shall be selected for the recycling hopper), which can calculate the color difference compensation according to the amount of recycled materials;
◆ optional coating treatment on the inner surface of the mixing drum to avoid the influence of raw materials on the batching accuracy due to static electricity;
(2 )住计量阀适用于5%及以上的比例,适用尺寸在6*6* 6mm以内的均匀颗粒原料或均匀颗粒回收料
(3 )次计量阀适用于0.5%-5%以下比例,适用尺寸在4*4*4以内的均匀颗粒色母料或添加剂
(4 )可适配微量计量阀，适用于0.2%-0. 5%的比例，适用于尺寸在4*4*4mm以内的均匀颗粒色母料或添加剂
(5 )可适配特材计量阀，适用于尺寸在12*12*12mm以内的片料或者不规则粉碎机
(6 )混合配比误差是指各组分的设定百分比与实际的差值，微量计量精度可控制在+0.1%
(7 )附赠一组次计量阀,以便更换配方需要时使用搅拌马达探用三相电源
